Windows Software Reference (Single Chamber Mode)
8-43
Enable the 'Remove XML from data' check box to remove the markup from the
data stream. The resulting data set is a data stream where each data field is
separated by a space.
CRC (Cyclic Redundancy Check) is an algorithm that is used to verify the integrity
of the data. Before each data packet is sent by the LI-8100A, a CRC is calculated
(pre-transmission) for that packet, and then appended to the packet. When the
client (e.g. the computer) receives the packet, it strips off the appended CRC and
calculates its own CRC (post transmission). If the two CRC values match, it is
assumed that the packet was transmitted correctly. When CRC values are
appended to the data packet, the value is automatically marked up. A typical CRC
will appear as
<CRC>3067450353</CRC>
Disable the 'Add CRC to data' check box to remove CRC from the data.
Click on the RS-232 or Wireless tabs to configure data values to be output over that
channel. You can configure either channel while connected to that channel;
however, changes will not take effect until you disconnect.
Help Menu
Help
Opens the on-line help index, where you can choose help topics related to the
Windows application software.
About
Displays the current LI-8100A Windows software version number and contact
information for LI-COR.
To Next Page
Loading...
