Using the 10 and 20 cm Survey Chambers
6-7
Software Setup Using the LI-8100A Windows Application Software
The following discussion assumes that you have installed the LI-8100A application
software on your PC, and are connected via the RS-232 or Ethernet cables
provided, or have configured the LI-8100A and your computer to communicate via
a wireless network, as described in Section 8, Windows Software Reference. The
measurement protocol is identical, regardless of how the PC is connected to the
LI-8100A.
1. Open the LI-8100A Windows application software and click on the Connect
icon, or choose Connect from the Communication menu. Choose the serial
(COM) port on the computer to which the LI-8100A is connected, and click
Connect. Alternatively, click on TCP/IP and enter the IP address of the
Ethernet card in the LI-8100A and click Connect. After a few moments, data
will begin to appear in the Main window.
2. Choose Measurement Configuration from the Setup menu. The Single
Chamber Configuration window appears.
To Next Page
Loading...
