8-14
Windows Software Reference (Single Chamber Mode)
Presets
After you have finished defining a set of measurement protocols, you can save the
definition as a Preset, which can then be recalled and applied globally, rather than
re-defining the protocol each time it is to be used. For example, you might have a
series of measurement protocols for daytime, nighttime, and diurnal measurements.
Any or all of these protocols can be saved individually for later recall.
Click Save Measurement Setup to save the configuration as currently defined to a
Measurement Preset. You are prompted for a filename for the Preset. After the
Preset is saved, you can save it to the computer by clicking Transfer to PC, and
choosing a destination for the file (by default, they are saved in a folder named
Presets in the LI-8100A Program Files folder). Preset files are appended with a .81p
file extension.
To load a Preset, choose a Preset from the list, and click Load Selected, or click
Load From File and locate the file on the computer.
Click Delete Selected to remove a Preset from the list.
To Next Page
Loading...
