EasyManua.ls Logo

LI-COR LI-8100A - Calibration Sheet; Optional Accessories; 6400-03 Rechargeable Battery

LI-COR LI-8100A
396 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Getting Started
1-7
Flat washer, #10 4 167-00154
Seal washer, #10 4 167-07255
8100-104/C Long-Term Chamber Gasket Kit
1 8100-612
Loctite Adhesive 1 208-05786
Collar Gasket 2 6581-060
Chamber Gasket Trim 6' 224-07606
6-32 x 3/8" screws 4 122-00009
4-40 x 3/8" screws 18 122-01578
Description Qty. LI-COR Part No.
LI-8100A Bellows Kit (optional) 1 8100-623
Silicone Lubricant 1 210-01958-1
10-32 x 1/2" screws w/o-ring 4 138-07470
Manifold Gasket 1 6581-057
Bellows, 3" I.D. x 4.25" O.D. 1 254-7219
Calibration Sheet
This data sheet is a copy of the calibration information entered into the LI-8100A
by LI-COR. Keep it in a safe place for future reference. LI-COR also retains copies
of calibration information for your soil CO
2
flux system; contact us if yours is
misplaced.
Optional Accessories
6400-03 Rechargeable Battery
(12VDC). The 6400-03 Rechargeable Batteries are tested and fully charged before
they leave the factory, but may discharge during shipping. It is a good idea to test
your batteries to make sure they are charged. See "Recharging the 6400-03
Batteries" in Section 12 for instructions about charging batteries. The 6400-03
batteries require the LI-6020 Battery Charger for recharging. One 6400-03 battery
provides approximately 3-4 hours of battery life, depending on pump usage,
wireless card usage, etc., at 25 °C. A mounting bracket and connectors are present
in the LI-8100A Analyzer Control Unit case for use with the 6400-03.

Table of Contents

Related product manuals