10-44
Using the LI-8150 Multiplexer
Port Sequence
The Port Sequence page defines the order in which ports (chambers) are sampled.
In most instances the ports are measured in sequential order (e.g. 1, 2, 3, 4, …16).
They can, however, be measured in any desired sequence by entering the order at
Port Sequence. Enter the port sequence, separated by commas (e.g. 1,8,8,13,1,9).
When LI-COR chambers are attached to the Multiplexer, they are automatically
detected, and displayed at Detected Chambers. If you want to measure the
chambers in the order they were detected, click on Use as Sequence. The order
will be automatically entered in the Port Sequence field. Click Redetect Chambers
To Next Page
Loading...
