Using the 10 and 20 cm Survey Chambers
6-15
Click the ‘Append data to an existing file’ button to add new measurement
data at the end of the currently defined file.
Destination
Data collected by the LI-8100A can be stored to the instrument's internal
memory, or to an optional Compact Flash card; you can log to one or the
other, but not both at the same time. Data stored to the internal memory can
be transferred to a Compact Flash card or to the PC at any time.
Measurement Start
Enter a Start time. You can start the measurement immediately or choose to
begin the measurement at a specified date and time.
6. Click Start Measurement to begin the measurement.
Software Setup Using the LI-8100A Apple iOS Software
The following discussion assumes that you have installed the LI-8100A application
on your iPod Touch (or other iOS device), and have configured the LI-8100A and
your iPod Touch to communicate via a wireless network, as described in Section 9,
iOS Software Reference.
1. Start the LI-8100APP. Tap Connect. Tap Connect To Instrument. Choose
an instrument from the list and tap Connect.
2. Tap Setup and choose Measurement Protocol. The Measurement Protocol
screen appears (below).
To Next Page
Loading...
