10-64
Using the LI-8150 Multiplexer
Charting
Select Charting to open the Charting window (below). This is the window in
which you can set up the parameters for plotting your real-time data. Two charts
can be plotted simultaneously, using Y axes on either side of the chart.
Series 1
The Series 1 options are used to plot a chart with the Y axis on the left side of the
chart. Choose the value to be logged, and set the maximum and minimum values
for the Y axis, or enable the ‘Auto Scale’ check box to allow the Y axis to scale
automatically to keep the data from running off of the chart.
Series 2
The Series 2 options are used to plot a chart with the Y axis on the right side of the
chart. Choose the value to be logged, and set the maximum and minimum values
for the Y axis, or enable the ‘Auto Scale’ check box to allow the Y axis to scale
automatically to keep the data from running off of the chart.
X-Axis Max
Sets the maximum value for the X axis (Time). The units for the X axis can be
seconds or minutes.
To Next Page
Loading...
