Using the LI-8150 Multiplexer
10-41
Port Setup: Data Logging
The Data Logging page contains a number of Optional Data Fields that can be
logged with each Observation. These fields are normally not used in any
calculations; if the Temperature Source, however, is mapped to V2, V3, or V4 (see
Chamber tab earlier in this section), that temperature may be used in calculations.
Choose Select All to enable all records, or Clear All to disable these records. If
you want to perform flux calculations after each Measurement is completed, enable
the ‘Perform Flux Computations’ check box.
To Next Page
Loading...
