EasyManuals Logo

Lorex LNR360 User Manual

Lorex LNR360
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #179 background imageLoading...
Page #179 background image
161
Appendix C: DDNS Setup (Advanced)
Accessing your NVR within a local network (LAN)
You can connect to your NVR on the local area network (LAN). It is recommended to
confirm connectivity over a local network before setting up your NVR for Internet
connectivity.
NOTE: To complete the steps below, your computer must be on the same network as your NVR.
Step 1 of 3: Connect your NVR to the Local Area Network
1 Power off your NVR by turning the power switch to .
2 Connect an Ethernet cable (included) to the LAN
port on the rear panel of the NVR. Connect
the other end of the Ethernet cable to an empty LAN port (usually numbered 1~4) on your
router.
3 Turn the power switch to I t
o power the NVR back on.
ROUTER
(Not Included)
COMPUTER
(Not Included)
(not required for
local viewing)
INTERNET
Ethernet Cable (included)
8-channel model shown
Step 2 of 3: Obtain the NVR’s Local IP Address
1 Right-click and select Information to open the System Information window.
NVR IP address
2 Write down the IP Address.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lorex LNR360 and is the answer not in the manual?

Lorex LNR360 Specifications

General IconGeneral
BrandLorex
ModelLNR360
CategoryDVR
LanguageEnglish

Related product manuals