24
Playback
Using the Playback Menu to Search for Recordings
You can use the Playback menu to search for recordings on the system. You can search by
time, by event type (e.g. motion), or by tags.
Normal Search
The Normal Search menu is used to search for video based on a specified start and end
time.
To search for video using a start and end time:
1 Right-click and then click Me
nu.
2 Enter the NVR’s user name (default: admin)
and password (default: 000000) and click OK.
3 Click Playback.
4 Under IP Camer
a, check the cameras you would like to search for video. Check IP Camera to
select/deselect all cameras.
Select cameras to
playback
Select recording
type
Select Start Time
Select End Time
5 Under Record Type, select the types of recording you would like to search for: Continuous &
Motion, Motion, Manual, or All.
6 Under Start Time, sel
ect the start time for your search. Click inside the field on the left and
use the calendar to select the start date. Click inside the field on the right and use the
buttons to adjust the start time for playback. Click outside the field to confirm the time.
NOTE: If y
ou right-click, it will exit the Normal Search menu.
7 Under End
Time, select the end time for your search in the same way that you selected the
Start Time.
8 Sel
ect one of the following:
• Cl
ick Playback t
o start playback at the earliest available footage in your selected time range.
To Next Page
Loading...
Need help?
General