Lorex LNR360 User Manual

48
HDD
To set S.M.A.R.T. settings:
1 Right-click and then click Menu.
2 Enter the system user name (default: ad
min) and password (default: 000000) and click Yes.
3 Click HD
D>HDD Detect.
4 Under HDD, sel
ect the hard drive you would like to check.
NOTE: You can see the HDD No. of installed hard drives under the HDD>G
eneral sub-menu.
5 Under Sel
f-test Type, select the type of S.M.A.R.T. test you would like to run.
6 Click
next to S.M.A.R.T. to begin the S.M.A.R.T. test. Wait for the test to complete.
Select S.M.A.R.T. test type
Click to start test
Select hard drive
Checking the Hard Drive for Errors
The NVR can check the hard drive for errors or bad sectors.
To check the hard drive for errors:
1 Right-click and then click Menu
.
2 Enter the system user name (default: ad
min) and password (default: 000000) and click Yes.
3 Click HD
D>HDD Detect>Bad Sector Detection.
4 Under HDD, sel
ect the hard drive you would like to check.
NOTE: You can see the HDD numbers of installed hard drives under the HDD>G
eneral
sub-menu.

Lorex LNR360 Specifications

General

Brand	Lorex
Model	LNR360
Category	DVR
Language	English