23
USB Memory Stick
RED: When a button is flashing red that particular track is ready to record.
GREEN: When a button is solid green that particular track has been recorded.
A button flashes green after the
ERASE procedure has been done. The track is empty but not
ready to record.
YELLOW: A button that is solid yellow indicates the ERASE button has been pressed in order to Erase
the contents of that particular track. The yellow color serves as a warning and gives you an
opportunity to change your mind before a recording is erased.
A flashing yellow
ERASE button indicates there is merged or replaced data will only be erased.
Merge and Replace Record and Merge/Replace-Erase procedures will be detailed later in this
section.
1.
PLAY FUNCTION: Press the track button(s) you wish to playback. Press the Play/Pause button and
playback of the selected track(s) will begin.
2.
PAUSE FUNCTION: Press the Play/Pause button during recording or playback to halt the process.
The button will flash green. Press Play/Pause again to resume the recording or playback activity at the
exact point where it was halted.
3.
YES FUNCTION: The yes function is used to complete a process. For example, pressing
Play/Pause button during the Erase function completes the erase procedure.
PLAY/PAUSE is a three function button. The appropriate function is assigned depending on what
function the Music Recorder is performing.
The STOP button ends the recording process or turns off a playback. When you press the Stop
button to end the recording session the Music Recorder returns to the beginning of the record-
ing. Simply press the
PLAY/PAUSE button for playback.
Pressing the Stop button during playback ends the song and returns the Music Recorder to
the beginning of the recording, again.
You can record your song by simply pressing one button! Press the RECORD button and it flash-
es yellow until you hear a metronome, at which time the Record button lights up solid red, indi-
cating the recorder is ready. The
PLAY/PAUSE button begins flashing red at this time. When
both track buttons are empty and ready for recording they begin to flash red, too. Recording
begins when you press any Key, Pedal or Button, or you may start the recording by pressing the
PLAY/PAUSE button.
ERASE deletes recordings from the tracks. After recording or playing a song, press the erase
button. The track buttons will turn yellow. Press and turn off any track buttons you do not wish
to erase. Press the PLAY/PAUSE button to erase the tracks. The track button erased will now
flash green confirming that the track has been erased.
ERASE
>>
<<
PLAY/
PAUSE
STOP
UPPER
RECORD
ACCOMP
RECORD
CONTROL
The six control buttons control the two Record Track
buttons.
To Next Page
Loading...
