25
USB Memory Stick
REPLACE RECORD
What It Does:
Replaces part of, or all of, what has already been recorded.
How It Works:
Once a track from a recording has been selected for Replace Record the Music Recorder will erase the ‘old’
notes as you play the ‘new’ notes. For example, if you wish to replace a part of a recording that is near the
end of a song you can simply ‘Fast Forward’ to that point in the song and replace that portion rather than re-
doing the entire piece.
How To Use It:
Follow these steps to see how Replace Record works.
1. Record a song and when finished, press the
STOP button.
2. Quickly press the
RECORD button two times. It will begin flashing yellow.
During Replace Record, the Record button flashes yellow until you begin to play, after which it flashes
r
ed. This confirms that the Replace Record has begun.
3. Press the UPPER track button. When you hear the ticking metronome sound it will change from solid
green to flashing red.
We ar
e using the Upper track button in this example. The same procedure can be used on the Accomp
track button.
4. Press the
PLAY/PAUSE button.
5. When the playback of the recorded song reaches the part you wish to replace, begin performing that
portion of the song.
6. When finished performing the new section of music, no matter how brief or long, or where it is
located in the recording, press the
STOP button
7. Press the
PLAY/PAUSE button to listen to the revised song.
MERGE RECORD-Erase Track
REPLACE RECORD-Erase Track
What It Does:
This feature erases the last Merge or Replace session that you performed. In the case of REPLACE RECORD-
ERASE TRACK, it erases what you played as a replacement and restores what was played before.
How It Works:
1. Quickly press the ERASE button two times. The TRACK buttons with no merged or replaced recordings
will flash green. The
TRACK buttons with merged or replaced recordings will be solid yellow.
2. Press off any (solid) yellow track buttons you do not want to erase.
3. Press the PLAY/PAUSE button to erase the track buttons (solid yellow) that were not pressed off in
Step #2. All the lights will become a solid green.
Use the
MERGE RECORD/REPLACE RECORD-ERASE TRACK feature to selectively delete additional record-
ed portions of your recorded songs.
To Next Page
Loading...
