214325 136 Revision A
Figure 4.85: Endshield Adjustment
2. Open endshield. Refer to 3.4.5 Opening Endshield,
page 83.
3. Loosen nut (A) on pin (B) from inside endsheet.
4. Close endshield and adjust position to achieve desired
gap between front end of shield and header frame in
accordance with Table 4.6, page 135.
5. Open endshield and tighten nut (A).
6. Check for a snug fit between top of shield and header
frame, and for full engagement of endshield on pin (B).
7. If necessary, loosen bolts on catch (C) and adjust catch
as required to reposition shield.
8. Tighten bolts on catch (C).
9. Close endshield. Refer to 3.4.9 Closing Endshield,
page 87.
PERFORMING PREDELIVERY CHECKS
To Next Page
Loading...
