214325 226 Revision A
Figure 5.185: John Deere Combine Display
2. Press – or + icon (A) to adjust rates.
NOTE:
The numbers depicted on displays in these illustrations
are for reference purposes only; they are not intended
to represent specific settings for your equipment.
Adjusting Manual Header Raise/Lower Rate (John Deere S and T Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator’s manual for updates.
Figure 5.186: John Deere Combine
Command Center
1. Press button (A) and current sensitivity setting will
appear on monitor.
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
