214325 236 Revision A
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator’s manual for updates.
Figure 5.209: CLAAS Combine Controls
1. Use < key (C) or > key (D) to select SENSITIVITY CAC,
and press OK key (E).
2. Use – key (A) or + (B) key to change reaction speed
setting, and press OK key (E).
Figure 5.210: CLAAS Combine Display
3. Use line (A) or value (B) to determine sensitivity setting.
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
