214325 259 Revision A
Figure 5.258: New Holland Combine Display
2. On HEAD 1 page, change CUTTING TYPE from FLEX
to PLATFORM as shown at (A).
Figure 5.259: New Holland Combine Display
3. On HEAD 2 page, change HEADER SUB TYPE from
DEFAULT to 80/90 as shown at (A).
Figure 5.260: New Holland Combine Controls
There are now two different buttons for ON GROUND
presets. The toggle switch that was present on
previous models is now configured as shown at right.
MacDon headers only require first two buttons (A)
and (B). The third button down (C) is not configured.
SETTING UP AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
