214325 296 Revision A
Table 8.1 Model FD75 FlexDraper
®®
/CA25 Combine Adapter Predelivery Checklist – North America
(continued)
üü
Item
Reference
Check header float.
IMPORTANT:
Install all options before setting float and wing balance.
4.11 Checking and Adjusting Header Float, page
105
Check wing balance.
4.12.1 Checking Wing Balance, page 110
Check auger flighting to feed pan clearance.
4.13 Adjusting Auger to Pan Clearance, page
119
Check knife hold-down adjustment.
4.7 Checking and Adjusting Knife Hold-Downs,
page 95
Check fitment of endshields.
4.19 Checking and Adjusting Endshields, page
135
Check skid shoes are evenly adjusted at a setting
appropriate for first crop.
4.16 Checking and Adjusting Skid Shoes, page
125
Check feeder house variable speed is set to minimum.
—
Grease all bearings and drivelines.
4.18 Lubricating Header, page 128
Check entire machine for shipping wires or strapping and
remove.
—
Run-up procedure
6 Running up Header, page 273
Check hydraulic hose and wiring harness routing for
clearance when raising or lowering header and reel.
—
Check lights are functional.
—
Check auto header height is calibrated and
functioning correctly.
5.1 Auto Header Height Control (AHHC), page
139
Check knife speed.
6 Running up Header, page 273
Post run-up check. Stop engine.
6.1 Performing Post Run-Up Adjustments, page
276
Check knife sections for discoloration caused by
misalignment of components.
6.1.1 Adjusting Knife and Guards, page 276
Check for hydraulic leaks.
—
Check that manual storage case contains all of required
manuals.
4.20 Checking Manuals, page 137
Date Checked: Checked by:
PREDELIVERY CHECKLIST
To Next Page
Loading...
