MacDon FlexDraper FD130 - Moving Rear (Right) Wheels into Field Position

214683 296 Revision A
10165141016514
A
B
Figure 3.522: Front Wheels
7. Lift the wheel assembly to the desired height and slide
the linkage (A) into the appropriate slot in the vertical
support.
8. Push down on the handle (B) to lock.
Moving Rear (Right) Wheels into Field Position
1001739
A
Figure 3.523: Rear Wheel – Left Side
1. Pull pin (A) on the left rear wheel. Swivel the wheel
clockwise and lock with pin.
1001740
A
C
D
B
Figure 3.524: Rear Wheel – Left Side
2. Remove pin (A) and store at location (B).
3. Pull handle (C) upwards to release.
4. Lift the wheel to the desired height, and engage the
support channel into slot (D) in the vertical support.
5. Push down on handle (C) to lock.
OPERATION