MacDon FlexDraper FD130 - Header Drapers; Removing Side Drapers

214683 485 Revision A
5.14 Header Drapers
There are two header drapers. They convey cut crop to the float module feed draper and auger. Replace the
drapers if torn, cracked, or missing slats.
5.14.1 Removing Side Drapers
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
1. Raise the reel and engage the reel safety props.
2. Raise the header and engage the safety props.
3. Move the draper until the draper joint is in the work area.
NOTE:
The D1 Series deck can also be shifted towards the center to provide an opening at the endsheet.
4. Shut down the combine, and remove the key from the ignition.
5. Release the tension on the draper. Refer to 5.14.3 Adjusting Draper Tension, page 488.
1010063
A
B
Figure 5.182: Draper Connector
6. Remove the screws (A) and tube connectors (B) at the
draper joint.
7. Pull the draper from deck.
MAINTENANCE AND SERVICING