MacDon FlexDraper FD130 - Installing Feed Draper Drive Roller

214683 472 Revision A
Installing Feed Draper Drive Roller
1013315
A
C
B
D
Figure 5.154: Drive Roller (Bearing End)
1. Apply grease to the spline.
2. Slide drive roller cover plate (A) onto right end of
roller (B).
3. Guide bearing end (C) of drive roller through frame
opening (D).
1013316
A
B
Figure 5.155: Motor
4. Slide left end of drive roller (A) onto spline of motor (B).
1013317
B
A
Figure 5.156: Drive Roller Bearing
5. Secure the bearing and housing (A) with the drive roller
cover plate on the frame using two bolts (B).
6. Install the feed deck draper. Refer to 5.10.1 Replacing
Feed Draper, page 466.
7. Tension the feed draper. Refer to 5.10.2 Adjusting Feed
Draper Tension, page 468.
MAINTENANCE AND SERVICING