214683 452 Revision A
4. Complete the hold-down adjustments, run the header at low engine speed, and listen for noise caused by
insufficient clearance.
NOTE:
Insufficient hold-down clearance will result in overheating of the knife and guards—readjust as necessary.
5.8.8 Knifehead Shield
The knifehead shield attaches to the endsheet and reduces the knifehead opening to prevent cut crop from
accumulating in the knifehead cut-out.
The shields and mounting hardware are available from your MacDon Dealer.
IMPORTANT:
Remove the shields when cutting with the cutterbar on the ground in muddy conditions. Mud may pack into the
cavity behind the shield which could result in knife drive box failure.
MAINTENANCE AND SERVICING
To Next Page
Loading...
