Mack M359 - Page 33

INTRODUCTION
WARRANTY CERTIFICATES
Standard
Normal Duty
Standard
Heavy Duty
Standard
Severe Duty
Weight Class
Qualications
Vehicle must have
GVWR ≤ 63,000 lbs. (≤ 28 metric ton)
or
GCWR ≤ 110,000 lbs. (≤ 50 metric ton)
Vehicle must have
GVWR ≤ 80,000 lbs. (≤ 36 metric ton)
or
GCWR ≤ 143,000 lbs. (≤ 65 metric ton)
Vehicle must have
GAWR > 46,000 lbs. (> 21
metric ton)
or
GVWR > 80,000 lbs. (> 36
metric ton)
or
GCWR > 143,000 lbs. (>
65 metric ton)
Basic Coverage * 12 months or
100,000 miles (160 934 km)
12 months or
100,000 miles (160 934 km)
12 months or
100,000 miles (160 934
km)
Chassis Towing
Towing/Road Service coverage is limited to 90 days or 5,000 miles (8047 km), whichever
occurs rst, and to a single tow per incident to the nearest authorized Mack Trucks service
center. Charges in excess of $1,000.00 are not covered unless Mack OneCall™ service is
contacted and approves additional amounts prior to tow.
Not Applicable
Air Conditioning Air conditioning (sealed system only) is covered for 12 months with no mileage limitation.
Engine / Emission Not covered under this warranty certicate. See respective engine manufacturer’s warranty certicate.
See paragraph 19 under Exclusions.
Transmission,
Driveline, Rear Axle,
Front Non-Drive
Steer Axle
36 months or 350,000 miles (563 270 km)
Covered Components are as follows:
• Manual Transmission – Transmission Assembly
• Driveline – Bearings, Hangers and Shafts
• Rear Axle – Differential Carrier Assembly and Axle Housing
• Front Non-Drive Steer Axle – Axle Beam, Steering Knuckle, and Tie Rod
12 months or
100,000 miles (160 934
km)
Allison Automatic Transmissions are not covered under this warranty certicate. See paragraph 19 under Exclusions.
Mack Carrier & Axle
Housing
60 months or
500,000 miles (804 672 km)
36 months or
300,000 miles (482 803 km)
12 months or
100,000 miles (160 934
km)
Mack T300
Transmission
60 months or
750,000 miles (1 207 008 km)
36 months or
400,000 miles (643 738 km)
12 months or
100,000 miles (160 934
km)
23
X Publication_PC28