Mack M359 - Page 48

INTRODUCTION
WARRANTY CERTIFICATES
GHG Covered Components
60 Months or 100,000 Miles (160 934 km),
whichever occurs rst.
(Only those vehicles certied as “Highway
Tractors” according to the requirements of
Chapter 40 of the Code of Federal Regulations,
Part 1037)
Qualications and Limitations
Exterior Components Limited to: Chassis Fairings, Ground Effect Extensions, Roof Deectors, Cab Side
Deectors, Adjustable Roof Extensions, Side Deector Extensions, Bumper Deectors, A-
pillar Deectors
Air Conditioning Components
Limited to: A/C Compressor, A/C Condenser, A/C Pressure Switches and Transducers,
Bunk Climate Unit, Hoses (Compressor to Condenser, Condenser to Drier, Drier to Climate
Unit, Climate Unit to Compressor, Bunk Climate Unit), Main Climate Unit, Receiver Drier
THESE LIMITATIONS AND EXCLUSIONS ARE IMPORTANT AND MUST BE READ AND UNDERSTOOD.
LIMITATIONS – Mack Trucks obligation is limited to, at its sole option, repair or replacement of parts which are acknowledged by
it to be defective. The defective parts or assemblies replaced shall become the property of Mack Trucks North America. Warranty
repairs performed by an authorized Mack dealer in accordance with the terms of the warranty set forth herein are free of charge.
Warranty consideration can only be given if the deciency is brought to the attention of an authorized Mack dealer upon discovery
and the vehicle must be made available, in a timely fashion during the coverage period, for repair.
EXCLUSIONS:
1. REPAIR: In the case of acknowledged defective Covered Parts, exchange with factory remanufactured parts may occur.
Warranty repairs do not constitute an extension of any warranty period for any vehicle, component or part.
2. DAMAGES: Damages due to misapplication, misuse, accidents, negligence, improper operations, alterations, storage or
transport, operation at excessive speeds, loading beyond the factory rated load capacity, failure to follow Mack Trucks’
recommended inspection, maintenance, and service procedures, and improper or insufcient maintenance services are not
covered.
3. PROGRESSIVE DAMAGE: Damages due to failure of operator to take reasonable precautions to mitigate damage are not
covered. Damages to a Covered Part due to failure of non-covered part are not covered. Coverage is limited to failure of a
Covered Part directly causing failure of a non-covered part, where reasonable precautions were taken to mitigate damages.
4. APPLICATION: The selling dealer is responsible for designating the correct application and/or specication for a vehicle sold to
a customer. Damages due to misapplication, including but not limited to, failures of component parts of vehicles being operated
in excess of factory rated load capacities, or the use of a vehicle, component or part for a purpose for which it was not intended
are not covered.
38
X Publication_PC28