Magicard Rio Pro - Page 74

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 74 -
SECTION 13 ERROR CODE LIST CONT.
Error Number
Displayed Error
Error Code
Description of Problem
19
Mag Verify Fail. Press Retry or Cancel to
continue.
19:01
Error is shown while processing a “Magnetic Self Verify”
command from the Support Utility (e.g. a pre-encoded
Card is read back by the Printer and the results displayed
in the Support Utilty). If the data read back from the Card
cannot be determined the error is displayed (e.g. could
be in a Non-ISO format).
Error Number
Displayed Error
Error Code
Description of Problem
20
Mode Unsupported. Cannot print requested
image with this printer model. Please cancel
print job and adjust Driver settings to try again.
20:00
Error can be shown while determining the format of the
downloaded print job. If colour printing has been
requested for the front of the Card but the Printer does not
support colour printing the error is displayed. Note that
this type of Printer does not yet exist and this feature is
reserved for future development.
20:01
Error is raised while determining the format of the
downloaded print job. If colour printing has been
requested for the back of the Card but the Printer does
not support colour printing the error is displayed. Note
that this type of Printer does not yet exist and this feature
is reserved for future development.
Error Number
Displayed Error
Error Code
Description of Problem
21
CLEAN REQUIRED. Please clean the Rollers
to avoid deterioration
21:00
Error can be shown if the cleaning prompt is enabled.
This prompt is displayed when the number of Cards
printed since the last clean exceeds the user configurable
threshold (by default 700). Note that this check is only
performed at Printer boot-up.
Error Number
Displayed Error
Error Code
Description of Problem
22
Test Results
22:00
Error is shown after executing a Sensor Test, initiated
using an SNS command. If the Printer found that the
Cam Sensor never changed then the error is displayed.
22:01
Error is shown after completing a Sensor Test, initiated
using an SNS command. If the Cam Sensor changed but
the Flip Sensor failed to unblock the error is displayed.
22:02
Error is shown after completing a Sensor test, initiated
using an SNS command. If the Cam Sensor changed but
the Flip Sensor never changed the error is displayed.
22:03
Error is raised after completing a Sensor Test, initiated
using an SNS command. If the Cam and Flip Sensors
both change the error is displayed.