EasyManuals Logo

Manitowoc 16000 Operator's Manual

Manitowoc 16000
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Reference Only
Manitowoc Published 05-09-17, Control # 011-29 3-73
16000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
WIND CONDITIONS
Wind adversely affects lifting capacity and stability as shown
in Figure 3-65
. The result could be loss of control over the
load and crane, even if the load is within the crane’s capacity.
Wind speed (to include wind gusts) must be monitored by job
planners and supervisors.
The wind speed at boom or jib point can be greater than wind
speed at ground level. Also be aware that the larger the sail
area of the load, the greater the wind’s affect on the load.
As a general rule, ratings and operating speeds must be
reduced when:
Wind causes load to swing forward past allowable
operating radius or sideways past either boom hinge
pin.
For wind conditions specific to this crane, see Wind
Conditions Chart at the end of this section or, if applicable,
see wind conditions in Capacity Charts provided with crane
and attachments.
WARNING
Tipping Crane Hazard!
Judgment and experience of qualified operators, job
planners, and supervisors shall be used to compensate
for affect of wind on lifted load and boom by reducing
ratings or operating speeds, or a combination of both.
Failing to observe this precaution can cause the crane to
tip or boom and/or jib to collapse. Death or serious injury
to personnel can result.

Table of Contents

Other manuals for Manitowoc 16000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc 16000 and is the answer not in the manual?

Manitowoc 16000 Specifications

General IconGeneral
BrandManitowoc
Model16000
CategoryConstruction Equipment
LanguageEnglish

Related product manuals