Manitowoc 16000 - Deploying Swing Radius Barrier; Storing Swing Radius Barrier

Reference Only
Manitowoc Published 05-09-17, Control # 011-29 2-7
16000 OPERATOR MANUAL SAFETY INFORMATION
2
Deploying Swing Radius Barrier
1. Remove pins (2, View C) from shipping position.
2. Rotate barrier arms (1) outward to working position
(View A).
3. Install pins (2, View B) in working position.
4. Pull on spring-loaded pins (3, View D), pull extension
arms (4) out part way, and release pins.
5. Pull extension arms (4) out fully until they are locked in
position by spring-loaded pins (5) as shown in View A.
6. Form a safety perimeter by attaching user supplied high
visibility rope or ribbon to hooked ends of extension
arms.
Storing Swing Radius Barrier
1. Remove rope or ribbon from hooked ends of extension
arms (4).
2. Pull on spring-loaded pins (3, View D), push extension
arms (4) in part way, and release pins.
3. Push extension arms (4) in fully until they are locked in
position by spring-load pins (5).
4. Remove pins (2, View B) from working position.
5. Rotate barrier arms (1) inward and install pins (2, View
C) in shipping position.
View A
Swing Radius Barriers
WORKING
View C
Swing Radius Barriers STORED
View B
View C
(4 places)
A13372
View D
(2 places)
Item Description
1 Barrier Arm
2Pin
3 Spring-Loaded Pin
4 Extension Arm
5 Rope or Ribbon
(user furnished)
1
2
FIGURE 2-3
1
3
3
4
5
1
3
4
2
1