Manitowoc 16000 Operator's Manual

Reference Only
Manitowoc Published 05-09-17, Control # 011-29 3-41
16000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
REMOTE CONTROLS
General
The following instructions identify and describe operation of
the remote controls used for crane assembly and
disassembly. Disregard any control not equipped on your
crane.
This crane has two types of remote controls:
• Electronic crane setup remote control:
- Wireless remotes are shown in Figure 3-25
- Wired Remote controls are shown in Figure 3-26
•Manual carbody remote control shown in Figure 3-33
Remote Control Priority
The following instructions apply only to Crane Serial Number
16001128 and newer.
The swing and travel alarm will sound continuously when a
function is being operated with any of the following controls:
• Carbody Manual Remote Controls — Priority 1
• Crane Setup Remote Control — Priority 2
• Wheeled MAX-ER
®
Setup Remote Control — Priority 3
• Hanging MAX-ER
®
Setup Remote Control — Priority 4
Additionally on cranes meeting 2010 European
Requirements with crane software version FCN 2.654 and
newer:
• No two remote controls can be operated at the same
time, each has an operating priority as indicated above.
• If you try to operate two remote controls at the same
time, the remote control with the higher priority will
operate. The other remote control will be disabled
(turned off).
WARNING
Read Instructions!
Avoid death or serious injury to personnel and damage to
crane:
• Read Crane Assembly and Disassembly Instructions
in Section 4 before operating remote controls.

Manitowoc 16000 Specifications

General

Brand	Manitowoc
Model	16000
Category	Construction Equipment
Language	English