Manitowoc 16000 - Crane Setup Remote Control Activation; Wireless Remote Control; Wired Remote Control

Reference Only
OPERATING CONTROLS AND PROCEDURES 16000 OPERATOR MANUAL
3-44
Published 05-09-17, Control # 011-29
Crane Setup Remote Control Activation
Wireless Remote Control
The wireless remote control can be operated in any mode.
A slight delay is normal from the time a remote toggle switch
is enabled to the time the corresponding function operates.
To turn on the remote control, proceed as follows:
1. Enter the function mode screen in the main display
(Figure 3-27
).
2. Scroll to and enter the setup screen (Figure 3-28
).
3. The screen in Figure 3-29
will appear.
4. Verify the TXID number on the screen matches the
number on top of the remote control. If not, enter the
proper number.
5. Hold down the power button on the remote control.
6. Scroll up or down to turn on the remote control.
7. Continue to hold down the power button on the
remote control until the remote control ON
prompt (shown to right) flashes in the display.
This could take 5-10 seconds.
The flashing prompt indicates the remote control is
communicating properly.
8. Exit the remote control data box to save the setting.
9. The remote control remains on (remote control ON
prompt remains in display) until it is turned off.
10. Reverse the steps to turn off the wireless remote.
Wired Remote Control
To turn on the remote control, proceed as follows:
Set-up remote control can be operated in any mode.
A slight delay is normal from the time a remote toggle switch
is enabled to the time a corresponding function operates.
To operate set-up remote control, proceed as follows:
1. Remove remote control from container on rear of cab.
2. Disconnect electric cable (WNE14T) from WN-OUT
receptacle on NODE 5 (see Figure 3-26
).
3. Connect electric cable from wired remote to WN-OUT
receptacle on NODE 5
4. Enter the function mode screen in the main display
(Figure 3-30
).
5. Scroll to and enter the setup screen (Figure 3-31
).
6. In function mode screen, enter the remote control data
box (Figure 3-32
).
Function
Mode
Screen
FIGURE 3-27
FIGURE 3-28
Past ProductionCurrent Production OR
FIGURE 3-29
Luffing Jib
Setup Screen
I = ON
O = OFF
Remote
Control
Screen
Past Production
Current Production
TxID Number
Function
Mode
Screen
FIGURE 3-30
FIGURE 3-31
Current Production