GLOSSARY14 - 2
D-MAXE with OI-B/OI-N www.maxcessintl.comMI 2-296 1 D
LOSS OF NULL
A signal asserted while in Automatic mode when the web is
sensed outside of a predetermined area of the active
proportional band.
LS (Line Speed)
Designation of the web speed signal which is supplied to X1.
Manual
Operating mode
There is no guiding of the web course.
OI (Operator Interface)
Designation of an operator interface.
OI-B: basic version
OI-N: network version
OSC
Designation of an optionally available oscillator.
PIC
Designation of an optionally available controller.
RCAL
Designation of an external input device for sensor calibration
RGPC (Remote Guide Point Control)
Designation of an external activation system for offset of the
guidepoint.
SC (Servo-Center)
SC is the abbreviation for the "Servo-Center" mode.
Servo-Center
Operating mode
The actuator is moved to the mechanical center position
depending on the Servo-Center transducer.
Servo-Center position
Then the control rollers of the actuator are aligned parallel to
the rollers of the customer system.
Servo-Center transducer
Assigns the Servo-Center position for "Servo-Center" mode
SGC (Speed Gain Control)
Guiding depends on web speed.
To Next Page
Loading...
Need help?
General
