CONTROLLER MENUS: 1Y.4 SERVO-CENTER7 - 16
D-MAXE with OI-B/OI-N www.maxcessintl.comMI 2-296 1 D
1y.4 Servo-Center This section describes menus that are used to set up the
properties for "Servo-Center" mode.
SC is used as an abbreviation for Servo-Center.
"Manual" mode:
– All parameters are available.
"Servo-Center" mode:
– Only selected parameters are available.
"Automatic" mode:
– These parameters cannot be set.
Menu 1y.4.1 SC Offset Note:
This menu is not available in the default configuration.
To Next Page
Loading...
