Maxcess D-MAXE - Proper Use of the D-MAXE System; D-MAXE System Options and Improper Use

INTRODUCTION 1 - 2
D-MAXE with OI-B/OI-Nwww.maxcessintl.com MI 2-296 1 D
Einführung.fm
Proper use The D-MAXE System is used to control systems such as:
– Control roller systems
– Unwind and rewind systems
– Slitting systems
– Tool positioning systems
The D-MAXE system works in different functions:
– Edge guiding
– Center guiding
– Line guiding (edge or center guiding on printed lines).
The D-MAXE system must only be used in accordance with its
intended purpose and must be in flawless technical condition.
Unauthorized conversions or changes to the D-MAXE system are
not permitted.
Any other use of the D-MAXE system requires the prior approval
of Maxcess.
Note:
The modules of the D-MAXE system must not be opened. If a
module is opened, no claims under the warranty will be
honored.
Options Customer-specific programming and different sensors and
actuators make it possible to adjust the D-MAXE system to a
wide variety of applications.
Improper use – Operation outside of the technical specifications is not
permitted.
– Operation in areas where there is a danger of explosions is
prohibited.
– Any use other than the designated use is not permitted.