II
3. Operations
Before operating the mechanical device, it is necessary to set the parameters with appropriate values. Otherwise,
can cause the mechanical device to out of control or break down.
Before running the mechanical device, make sure the emergency stop switch can work at any time.
Performing trial run without load, make sure that the servomotor is in normal operation. Afterwards joins again
the load.
Please do not turn on and off the main power supply more frequently, otherwise can cause the servo driver
overheat.
4. Running
Do not touch any moving parts of the mechanical device while the servomotor is running, otherwise can cause
personnel casualty.
Do not touch servo driver and servomotor while the equipment is operating, otherwise can result in an electric
shock or in burn.
Do not move any connection cables while the equipment is operating, otherwise can result in physical injure or
equipment damage.
5. Maintenance and inspection
Do not touch any portion inside of the servo driver and servomotor, otherwise can cause an electric shock.
Do not remove the front cover of the servo driver while power is on, otherwise can cause an electric shock.
Please wait at least 5 minutes after power has been removed before touching any terminal, otherwise the
remaining high voltage possibly can cause an electric shock.
Do not change the wiring while the power is on, otherwise can cause an electric shock.
Do not disassemble the servomotor, otherwise can cause an electric shock.
6. Service ranges
This handbook involves the product for the general industry use, please do not use in some equipment which may
directly harm the personal safety, such as nuclear energy, spaceflight, aeronautic equipment, and life safeguard,
life-support equipment and each kind of safety equipment. Please make contact with the company if have the need of
use mentioned above.
To Next Page
Loading...