Maxsine EP3 E Series - Page 96

Chapter 5 Parameters
88
P315 User-defined PZD receiving word
Range
Default
value
Unit Usage
0～2 0 ALL
 You can set this parameter to select the user-defined PZD content in the received packets.
 Parameter meaning:
0: meaningless.
1: Additional torque (function to be improved);
2: Additional speed (functions to be improved).
P316 User-defined PZD sending word
Range
Default
value
Unit Usage
0～3 0 ALL
 You can set this parameter to select user-defined PZD content in the sent packet.
 Parameter meaning:
0: meaningless.
1: actual torque, unit %;
2: actual current, unit: 0.1a;
3: DI state, Bit0 ~ Bit4 said DI1 ~ DI5, respectively.
P320 Ramp acceleration time
Range
Default
value
Unit Usage
0～30000 1000 ms ALL
 Sets the acceleration time of the motor from zero speed to rated speed.
 If the command speed is lower than the rated speed, the acceleration time required is
correspondingly reduced.
 This parameter has no effect in the application class AC4.
P321 Ramp deceleration time
Range
Default
value
Unit Usage
0～30000 1000 ms ALL
 Sets the acceleration time of the motor from zero speed to rated speed.
 If the command speed is lower than the rated speed, the acceleration time required is
correspondingly reduced.
 This parameter has no effect in the application class AC4.
P322 Rapid deceleration time
Range
Default
value
Unit Usage
0～30000 100 ms ALL
 Set deceleration time of motor from rated speed to zero speed.
 If the current speed is lower than the rated speed, the deceleration time required is
correspondingly shortened.
 This parameter is valid only during rapid deceleration.