Meggitt VM600 Hardware Manual

VM600 MPS hardware manual (standard version) MAMPS-HW/E 10 - 15
Edition 17 - February 2018
Slot number coding for IOC8T cards
CONFIGURATION OF AMC8 / IOC8T CARDS
NOTE: Pay attention to the polarity of the micro-switches!
Note that “0" corresponds to ON.
10.7.2 VM600 slimline rack (ABE056)
When an IOC8T card is installed in a VM600 slimline rack (ABE056), the micro-switches on
the backplane of the rack must be configured to match the slot number configured for the card
(see 2.1.4 Slot number coding for cards in the rear of an ABE056 rack). This allows the
IOC8T to be used in an ABE056 rack without reconfiguring its slot number.
Figure 10-10: Position of micro-switches to assign the IOC8T slot number (ABE04x)
and configure relays as NE/NDE
Switches 5 to 8
On=NDE
Off=NE
IOC8T card micro-switch settings for installation in slot 11
of an ABE04x rack
LSB = Least-significant bit
MSB = Most-significant bit
Connector P4
(To J4)
Switch number
Hole
Raised part of switch
Text etched on PCB
(Top of card)
MSB
LSB
(code=1011)
IOC8T
RL4 RL3 RL2 RL1
(Bottom of card)

Meggitt VM600 Specifications

General

Brand	Meggitt
Model	VM600
Category	Measuring Instruments
Language	English