VM600 MPS hardware manual (standard version) MAMPS-HW/E C - 1
Edition 17 - February 2018
DEFINITION OF BACKPLANE CONNECTOR PINS
C DEFINITION OF BACKPLANE CONNECTOR PINS
This appendix defines the pins on backplane connectors P1, P2, P3 and P4.
The definition of pins on each connector depends on the position of the connector on the rack
backplane (that is, in which slot it is used). The information is presented in tabular form for
the following groups of slots:
• Slot 0 (see Figure C-1)
• Slots 1 and 2 (see Figure C-2)
• Slots 3 to 14 (see Figure C-3)
• Slots 15 and 18 (see Figure C-4).
To Next Page
Loading...
Need help?
General
