mensor CPC6050 - Settings Application

38 Operating Instructions - CPC6050
Modular Pressure Controller
CPC6050
6.4.2 Settings Application
The Settings App is used to set up general settings for the display. Settings parameters include
Language, Brightness, Volume, User 1 base units, User 1 multiplier, User 2 base units, User 2
multiplier, Barometer units, and Conguration. Figure 6.4.2 shows these parameters as indicat-
ed when the Settings App has been chosen. As each parameter is pressed, an input screen will
appear on the right where selections can be made.
The Settings App provides a place to change the language, display brightness, volume, user units, and
barometer units. Conguration settings of the unit can also be saved within this application plus the de-
fault conguration can be activated.
Figure 6.4.2 - Settings application
6.4.2.1 Languages
The Language parameter provides a selection of dierent languages. Once a language is chosen all
words within all menus will appear in the chosen language and the radix character (decimal mark) will
change from a dot (.) to a comma (,) depending on the language chosen. More languages can be ac-
cessed by navigating to the next page of the language selection menu on the right side of the screen.
Figure 6.4.2.1 - Languages