mensor CPC6050 - Ethernet

Operating Instructions - CPC6050 71
Modular Pressure Controller
CPC6050
7.5 Ethernet
The Ethernet function allows the user to set the following by inputting a numeric value in each separate
eld:
• IP
• Netmask
• Gateway
• Port
• DHCP settings
Set the Ethernet communication parameters as described in Section 6.4.5.
!
Caution
CAUTION: Please contact your network administrator for proper settings.
!
Caution
CAUTION: Please consult your computer resources department prior to connect-
ingthisinstrumenttoyournetworktoverifytherearenoconictswithexistingIP
addresses.
The Ethernet communication port allows the CPC6050 to communicate with computers using
10/100Based-T specications.
Before using Ethernet communication, four parameters must be set up: IP, Netmask, Gateway, and Port.