mensor CPC6050 User Manual

Operating Instructions - CPC6050 105
Modular Pressure Controller
CPC6050
:DEFine[N] <”CCC”, f> Sets the user dened units for index N. If N is not
sent, will default to user units 1. Requires the de-
sired unit name in double quotes, multiplication
factor from Pascal (base units is always Pascal).
Index N is 1 or 2
7.10.2 Error Messages
All remote commands sent to the CPC6050 are shown in the Trouble Shooting App, under the “Remote”
button. If there is a syntax error, an error message will appear below the errant command. Local errors
and remote command errors will appear under the “Error” button. Maximum of 100 errors are stored and
can be retrieved.
The error messages can also be seen remotely when “SYST:ERR?” is sent any error in the error queue is
returned, otherwise the following is returned: 0,“No Error”.
Error String Returned
0, “No error”
1,”Overow” (occurs when remote interface buer of commands has become full. Command will not be
processed)
102, “Syntax error”
102,”Syntax error;Unbalanced string.”
105,"Parameter not supported, parameter 1"
105,”Parameter not supported, parameter 2”
108,”Parameter not allowed”
109,”Missing parameter”
113,”Undened header”
113,”Command Unknown”
114,”Parameter Out Of Range”
114,”Header sux out of range”
131,”Invalid sux;Unit sux not dened.”
200,”Execution error;Query or command violation”
200,”Execution error;Type mismatched, parameter 1”
200,”Execution error;Type mismatched, parameter 2”
203,”Access error; Incorrect password”
220,”Parameter error”
240,”Hardware error
500,”<s>” (where <s> is the undened error error string generated by the pneumatic module)
201,”Query only”
207,”Enumeric value not in union”
602,”Sensor not available”
999,”<s>” (where <s> is the undened (unique) error string)

mensor CPC6050 Specifications

General

Brand	mensor
Model	CPC6050
Category	Controller
Language	English