58 Operating Instructions - CPC6050
Modular Pressure Controller
CPC6050
Table 6.4.7.1 - Sequence Commands
Command Function (data selection)
CHAN Sets the active channel for subsequent commands
RANGE Sets the active range for the active channel
WAIT Waits for a manual input or stable condition (Stable or Input)
DELAY Delays for time = 1 to 3600 seconds (Numerical Entry)
MODE Sets the control mode (Measure, Control or Vent)
UNITS Sets the units for the active channel
PTYPE Sets the pressure type (Gauge or Absolute)
SETPOINT% Sets the control setpoint in % of current range (Numerical Entry)
SETPOINT Sets the control setpoint for the instrument (Numerical Entry)
STEP% Increases or decreases the current setpoint by the percent full
scale specied
STEP Increases or decreases the current setpoint in current units (Nu-
merical Entry)
RSETPT Sets the rate setpoint in current units (Numerical Entry)
SEQZERO Set the zero for the current active transducer
SEQSTART Starts the sequence from the beginning (None)
RUNITS Sets the rate denominator time unit (min or sec)
To Next Page
Loading...
Need help?
General
