mensor CPC6050 - Page 83

Operating Instructions - CPC6050 83
Modular Pressure Controller
CPC6050
Runits? <sp>XXXX<cr><lf> Returns the rate time unit
Save_cal Save calibration values
Save_linearity Save linearity values
Sbaud 9600, 19200, 38400, 57600, 115200 Sets the serial baud rate
Sbaud? <sp>XXXX<cr><lf> Returns the serial baud data
Sdata 7 or 8 Sets the serial data bits
Sdata? <sp>n<cr><lf> Returns the serial data bits number
Sensor 1,2,P,S, PRIMARY, SECONDARY
11, 12, 21, 22
P1, P2,S1,S2
P, 1
P, 2
S, 1
S, 2
Sets the active sensor. Accepts mul-
tiple format types including sensor
only, or sensor and turndown.
Sensor may be specied with
P,S,1,2,3,4 (3,4 for autoranging
single-ouptut only).
Turndown specied with 1, 2.
Sensor and turndown may not be
delimited or be delimited by comma,
or space
Sensor? <sp><s><td><cr><lf> Returns active transducer in long
string format
Sensorid? <sp>Mensor,SN XXXXXX, VN.NN Returns the active transducer’s serial
number and rmware version
Setpt Value inside upper and lower limits Sets the control setpoint for the instru-
ment
Setpt? <sp>XXXXXXX<cr><lf> Returns the control setpoint in current
units.
Setpt% Value in % of primary range Sets the control setpoint in % of pri-
mary range
Setptpct Value in % of primary range Sets the control setpoint in % of pri-
mary range
Setptpct? <sp>n.nnnnnE+nn<cr><lf> Returns the current setpoint in % of
primary range
Setpoint Value in % of primary range Sets the control setpoint in % of pri-
mary range
Setpoint? <sp>n.nnnnnE+nn<cr>
<lf>
Returns the current setpoint in % of
primary range
Setpointpct Value in % of primary range Sets the control setpoint in % of cur-
rent range
Setpointpct? <sp>n.nnnnnE+nn<cr>
<lf>
Returns the current setpoint in % of
primary range
Span Desired pressure or ? Sets span on active transducer or for
?, clears previous value, must be >
50% FS and has a 1% limit. CALDIS-
ABLE must be OFF/NO.