Chapter 8 Dealing with Problems
168
Error
number
Message Cause Corrective action
C06 BUFFER • An error occurred in the
receive buffer.
C08 POWER • An error occurred related
to the motor.
C10 Commands • Received a code other
than a COMMAND code.
Check the following points:
1. Clear the data and resend.
2. "Turning Off the Power"(P. 38)
3. Check the USB cable connection.
"Using a USB Cable"(P. 33)
4. Use a compliant USB cable. "USB
Connection Precautions"(P. 33)
C11 PARAMETER • Received parameter
outside numerical value
range
C12 DEVICE • Received an invalid
device control command.
C13 PM OVER • The polygon buffer
overflowed.
• Either set so as not to use polygon
commands or use the MGL-lc1
command.
C15 AUTO FEED • The length specified by
the ZX command could
not be fed.
• Reset the long sheet after data has
been sent from the host computer,
then perform multiple sheet cutting.
• The previous sheet
length could not be fed
for the second sheet data
onward during divided
cutting.
• Load a long sheet, then switch to
remote mode again.
C16 AUTO I/F • The command could not
be automatically
recognized.
• Set the command name. "SET
UP"(P. 135)
C20 I/O • An error occurred in the
communication
conditions.
• Adjust the communication conditions
to match the host computer. "SET
UP"(P. 135) > [INTERFACE]
C27 BUFFERover • An error occurred in the
interface.
• Check the interface cable.
C31 NO DATA • Multiple sheet cutting
was executed, but no
data is saved to the
receive buffer.
• Cut the data involved once more.
C32 DATAtooBIG • The received data is too
big for multiple sheet
cutting.
• Change the data size.
C33 SHEET SIZE • The sheet is too short in
the feed direction.
• Use a longer sheet.
C36 MARK DETECT • Unable to detect register
marks
Check the following points:
1. Check to confirm the register marks are
placed properly. "Register
Marks"(P. 80)
2. Use an uncurled sheet.
3. Check the mark detection start position.
4. Check to confirm the register marks are
black and printed on a white background.
5. Check to confirm the area between the
register marks is clean and free of printing
and images.
To Next Page
Loading...
Need help?
General
