Chapter 1 Before Using This Machine
35
4
Press to select the following communication conditions, then press the [ENTER/HOLD]
key.
• Communication conditions: Data bits, parity, stop bit, handshake, step size, close time
5
Press to select the setting, then press the [ENTER/HOLD] key.
• Fore more information on the individual settings, refer to "Notes on the setting items"(P. 35).
6
Press the [END] key several times to exit.
l
Notes on the setting items
BAUD RATE 1200, 2400, 4800, 9600, 19200, 38400 (bps)
Data bits 7, 8 (bit)
Parity NON, EVEN, ODD
Stop bits 1, 2 (bit)
Handshake AUTO (MGL-IIc) HARD, ENQACK, X-PRM, SOFT
MGL-IIc HARD, ENQACK, X-PRM, SOFT
MGL-Ic1 HARD, XONOFF
Step size AUTO (MGL-IIc) 0.025 (mm)
AUTO (MGL-Ic1) 0.05 (mm)
MGL-IIc 0.025, 0.01 (mm)
MGL-Ic1 0.05, 0.025, 0.1 (mm)
Close time
*1
3 to 60 (Seconds)
*1. Sets the data interval for multiple sheet cutting, and the waiting time before start of dividing cutting or
sorted output. The value can be set from 3 to 60 seconds. If no data is received within the time set after
cutting has ended, it is determined that one set of data has ended, allowing separation from the next set of
data.
1
To Next Page
Loading...
Need help?
General
