Chapter 2 Cutting
71
Item Messag
e
Tool Setting Step size Outline
Pressur
e
PRES
S
Cutter/
creasin
g
*1
10 to 550
g
2 g (10 to
20 g)
5 g (25 to
100 g)
10 g (110
to 550 g)
• Sets the pressure for cutting, creasing, or pen
writing.
• This setting is also required for half cuts.
pen 10 to 150
g
Offset OFFSE
T
Cutter 0 (0.00) to
250 (2.50
mm)
0.05 mm • Sets the length from the center of the cutter holder
to the cutting blade.
Cutter holder
Cutting blade
Offset
Half cut HALF Cutter ON/OFF • Cuts across a dotted line without cutting out the base paper.
[Pressure]
Cutter
[H-Leng][C-Leng]
[Half Cut Pressure]
Label film
Base
paper
• If HALF CUT is set to "ON", the three items listed below are
displayed: Set the following three items and pressure in the
Cutting Conditions menu:
Half
cut
press
ure
H-
PRES
Cutter 0 to 300 g 5g • Sets the pressure for the uncut portion.
Uncut
length
H-
LENG
Cutter 0.1 to 5.0
mm
0.1 mm • Sets the uncut length.
Cut
length
C-
LENG
Cutter 5 to 150
mm
1 mm (5
mm to 20
mm)
5 mm (20
mm to 150
mm)
• Sets the cut length.
*1. The creasing tool is optional. "Using the Creasing Tool"(P. 67)
2
To Next Page
Loading...
Need help?
General
