Chapter 4 Cutting Data with Register
Marks
This chapter
This chapter describes the requirements for creating register marks and provides basic
information. Adjustments apply to CJV200 models.
Process for Cutting Data with Register Marks
......................................................................102
Creating Register Marks................................104
Register Marks ......................................... 104
Register Mark Size................................... 105
Spacing Between Register Marks ............ 106
Reading Range of Register Marks ........... 107
No-Plotting Areas Around Register Marks 108
Combined Operations of Printing and Cutting
................................................................. 109
Setting Mark Detection Conditions .................110
Detecting the Position of the Register Mark
Origin..............................................................111
ID Cut Process ...............................................112
To Next Page
Loading...
