Chapter 2 Printing
84
2.14 Cutting the media
1
On the LOCAL mode screen, press .
• The Origin Setup screen appears.
2
Press to feed the media to the position required for cutting.
3
Select [CUT].
4
Press the [ENTER] key.
• The media is cut.
When the machine is not in use, raise the clamp lever to separate the pinch rollers from the grit
rollers.
• Leaving the pinch rollers lowered may cause them to become deformed and prevent media from
being fed correctly.
• Leaving media loaded will subject it to force from the pinch rollers, which may leave pinch roller
marks on it.
To Next Page
Loading...
