Chapter 2 Printing
82
Starting Printing
1
Send the RIP data from the PC.
• "Preparing RIP data"(P. 79)
• If the message "Attention20A Driver version" appears, install the latest Mimaki driver.
https://mimaki.com/download/inkjet.html
2
Start printing.
• Printing starts once RIP data is received.
NRS 0.0m
600x600 16p / Bi / Hi / Vd
[Resolution]
[Number of passes]
[Scan direction] (Uni: unidirectional, Bi: bidirectional)
[Scan speed] (Std: standard, Hi: high speed)
[Dot type]
VD: Variable dot
ND: Normal dot
Length of medium printed
[Nozzle Recovery]
: A part of nozzles can be recovered
: All nozzles can be recovered
: Not registered or the print mode
where nozzles cannot be recovered
NRS
NRS
OFF
• Print speeds may differ for the same image data, depending on the width of the medium
loaded, print origin position, and resolution.
• If an error occurs, the machine switches to LOCAL mode once printing is completed.
Further printing is not possible.
• If there are nozzles that cannot be recovered, "Nozzle recovery not possible" will be
displayed at the start of printing. If nozzle clogging is noticeable, try increasing the number
of passes or changing the resolution.
Pausing Printing
1
Press [LOCAL] while printing is in progress.
• Printing is paused.
• If data is being sent from a PC, data transmission is paused at the PC.
2
Press [REMOTE].
• Printing resumes.
• No other functions can be used when printing is paused.
To Next Page
Loading...
