MIMAKI CJV200-160 - Cleaning the NCU (Option)

Chapter 6 Maintenance
142
7
Reattach the wiper at the original position.
Lug
• Do not remove the absorber pad in the pad case. Doing so may result in leaking ink.
8
Once cleaning is complete, close the cover, then press the [ENTER] key.
Cleaning the NCU (Option)
The NCU uses a sensor to monitor the ink droplets ejected from the print head nozzles. Continuing to use
the dirty NCU may prevent the nozzle check function from operating correctly.
• Be careful to avoid leaving fragments from the cleaning stick behind when cleaning. These
fragments will increase the risk of ejection failures (e.g., nozzle clogging or deflection).
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Carriage Out] > [Move To Platen Right End], then press the [ENTER]
key.
• The carriage moves over the platen.
3
Open the maintenance cover (right side).
4
Clean the NCU.
• Wipe off any ink and dust adhering using a cleaning stick moistened with maintenance liquid. Wipe
off the maintenance liquid. Make sure none remains.