MIMAKI CJV200-160 - Error Message

Chapter 7 Troubleshooting
176
Cartridge (600 ml) related
Message Cause Corrective action
Ink Level Low • The ink level in the 600 ml
ink cartridge is less than
60 ml.
1. Remove the ink cartridge and weigh it.
"Correct the ink cartridge weight"(P. 126)
2. Enter the measured weight into the
machine. "Correct the ink cartridge
weight"(P. 126)
INK NEAR-END • The ink level after
cartridge weight
correction ( "Correct
the ink cartridge
weight"(P. 126)) is less
than 60 ml.
Ink Level End • The ink level in the 600 ml
ink cartridge is less than
25 ml.
1. Remove the ink cartridge and weigh it.
"Correct the ink cartridge weight"(P. 126)
2. Enter the measured weight into the
machine. "Correct the ink cartridge
weight"(P. 126)
Replace Ink pack (Ink End) • The ink level after
cartridge weight
correction ( "Correct
the ink cartridge
weight"(P. 126)) is less
than 30 ml.
1. Replace the ink pack. Replacing Ink
Error Message
Error
number
Message Cause Corrective action
04 PARAM ROM • A problem was detected
with the main PCB.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
108 HD THERMIS[1] • A problem was detected
with print head
temperature control.
108 HD CONNECT[1] • A problem was detected
with the print head
connection.
108 HD MEM EMP[1] • A problem was detected
with the print head.
10e FROM CLEAR • A problem was detected
with the main PCB.
10f FROM WRITE
122 CHECK:SDRAM • A problem was detected
with the SDRAM.
123 PRAM DATA • A problem was detected
with the main PCB.
124 PRAM ADDR
127 POWER OFF
128 HDC FIFO OVER • A problem was detected
with the print head control
PCB.
128 HDC FIFO UNDER