Chapter 6 Maintenance
140
4
Open the maintenance cover (left side).
5
Clean around the print head.
• Wipe off any ink and dust adhering using a cleaning stick moistened with maintenance liquid. Wipe
off the maintenance liquid. Make sure none remains.
Never touch the
nozzle surface!
Clean the print head sides using a cleaning stick.
Clean using a cleaning stick or soft cloth.
• Never touch the print head nozzle surface.
6
Once cleaning is complete, press the [ENTER] key.
• The carriage moves back to its original position.
7
Close the maintenance cover (left side), then attach the maintenance cover (upper left side).
Wiper Cleaning
The wiper wipes off ink adhering to the print head nozzle surface. Continuing to use with a dirty wiper may
cause dried ink and attached dust to damage the head nozzle surface, and could lead to ejection failures
(e.g., nozzle clogging or deflection).
• Be careful to avoid leaving fragments from the cleaning stick behind when cleaning. These
fragments will increase the risk of ejection failures (e.g., nozzle clogging or deflection).
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End], then press the [ENTER] key.
• The carriage moves over the platen.
To Next Page
Loading...
